Industrial Flooring FAQ

Our main service is vacuum dewatering (VDF) flooring. We also provide laser screed FM2 flooring, densification dust proofing, concrete floor polishing, truss screed flooring, jointless concrete floors, concrete floor and slab cutting, waterproofing and epoxy flooring.

We are based near Denso Chowk on SIDCUL Bypass Road, Haridwar, Uttarakhand. Tell us where your site is and we will confirm whether we can take the project on.

Yes — that is our focus. We work on warehouses, factories, production units, workshops, commercial buildings, parking areas and similar projects.

For most projects, yes. We look at the slab or substrate, levels, access, and the conditions the floor will face before quoting, so the price and the method reflect the actual job rather than an assumption.

There is no honest flat rate for industrial flooring, because two floors of the same size can be very different jobs. The price depends on the floor area, the condition of the site and existing slab, the material or system, its thickness, the project requirements and specification, the location, and the full scope of work — including preparation, repairs, joints and finishing. We give a price once we understand these.

The site location, the approximate floor area, what the floor will be used for, drawings or specifications if you have them, photographs of the existing floor for repair or refurbishment work, and your intended timeline. The enquiry form asks for the essentials.

Most of a floor's cost over its life comes from repairs, downtime and cleaning, not from laying it. Short cuts on preparation, curing or joint timing save little at the start and often lead to dusting, cracking or coating failure that costs far more to put right in a working building.

For a new warehouse, a vacuum dewatered concrete floor — usually laid with a truss screed and often with a floor hardener — is the standard choice for strength and wear resistance. For an existing warehouse floor that is dusting, dustproofing is usually the most cost-effective fix. Where hygiene or sealing is needed, epoxy is used.

A VDF floor is the concrete slab itself, made denser and harder by removing surplus water as it is laid. Polished concrete is a slab — new or existing — that has been densified and diamond ground to a hard, reflective finish. Epoxy is a resin layer applied on top of a prepared slab to give a seamless, sealed, chemical-resistant surface. Many floors combine them: a VDF slab can later be polished or coated with epoxy.

Often, yes, with planning. Work can be phased area by area, carried out at night or during shutdowns, and dusty or noisy stages scheduled to suit you. What is possible depends on the service and the site, and we agree it before starting.

It depends on the area, the service, and how much of the site is available at once. Concrete floors are cast bay by bay and then need a curing period before heavy use; resin floors need time to cure before traffic. We give a programme with the quotation, including when each area can be back in use.

Keep it swept and scrubbed so grit does not act as an abrasive, clean up oil and chemical spills promptly, avoid dragging heavy steel items across it, and check joints periodically — refilling joint sealant where it has worn stops the edges chipping under wheels.